M60/62 Turbo kit....in the works

[CarsonE30]

I'm still just waiting to see if it will fit in an E34

[makaveli2k]

Nicely done!

I doubt it would fit an e34 as it is. The crossover pipe goes right through where the power steering pump would be. I very well could be mistaken but I have yet to see an e34 without power steering (wouldn't envy the poor bast add either.)

[driftingminor913]

Like I said this is the first one so when someone wants a manifold that has power steering I'm sure I can make the manifold go around or under their power steering pump

[King Mufasa]

Sweat, finish her off now!! Pipes are craving torque

[driftingminor913]

Just waiting on more funds, and flywheel to be finished. I took my clutch into a local clutch shop n they beefed up my clutch to handle a lot more abuse n was only fairly cheap for what they did n it's the same quality as a Centerforce or Spec but will post pics when I get it

[driftingminor913]

Going to try n shoot to start this week or weekend. I will try to figure out how to load up a video on here if I do

[CarsonE30]

Going to try n shoot to start this week or weekend. I will try to figure out how to load up a video on here if I do

Hell yeah, looking forward to this!

[goarmy]

That's what I had on hand but when I make them again I will be sure to combine them so it's one big flange

Why?.. It'll just will be more weight!

[driftingminor913]

A lot cheaper to make and easiest to Weld on one big plate then a smaller individual flange

[driftingminor913]

Bought some of these to seal Up the oil system

It's coming along, going to grab my old flywheel to start and some other odd ends.
SOORY FOR THE BAD QUALITY PICS DOING THIS ALL FROM MY IPHONE :-/

[Denny]

Looking awesome... one thing I would do is a quick Tab "brace" with lower pipe on the available treads of the oil pan

[Old city bimmer]

I would have remove the oil filter housing and relocated it. and run the pipe through there.

I'm my old 84 300zx v6 turbo the pipe from the drivers side went across the top of the transmission. Too bad there's not enough space for something like that.


Sent from my iPad using Tapatalk

[driftingminor913]

[driftingminor913]

Like I have said this is for e30's but for my setup is a e36. This is the first of many kits I will
Make and will make the next one a bit lower and a inch or so back near the strut tower so it won't interfere with the core support like it did on mine.

[makaveli2k]

Very cool! Just curious. What oil pan are you using?