Rotor set screw

[BS87]

Needs to be replaced every time, correct? Searech turned up nothing, oddly enough.

[Jordan]

Only if something is wrong with it.

[BS87]

Thanks, figured i'd just check.

[nando]

they tend to rust/strip, and they're cheap, so no reason not to replace them..

[BahnE30]

don't need it, lugs will hold it on there fine. i don't know of anyshops that actually put them back in when rotors are done, they're a pain in the ass to get out next time anyway.

[DanGillan]

don't need it, lugs will hold it on there fine. i don't know of anyshops that actually put them back in when rotors are done, they're a pain in the ass to get out next time anyway.

you're a moron, if shops arent putting them back on the shop is a hack piece of shit. they're there for a reason.

[alex]

don't need it, lugs will hold it on there fine. i don't know of anyshops that actually put them back in when rotors are done, they're a pain in the ass to get out next time anyway.

Antiseize baby!

I betcha you'll have a hell of a time trying to start your lug bolts if your rotor is:
-1- not staying in place trying to fall of
-2- staying in place, but rotating as you rotate the wheel making it quite an interesting affair.

I think the above 2 should make it worthwhile to put that screw back in. As I mentioned use antiseize and hand tighten it only.

[nando]

don't need it, lugs will hold it on there fine. i don't know of anyshops that actually put them back in when rotors are done, they're a pain in the ass to get out next time anyway.

that's because they're too lazy and too cheap to buy 50 cents worth of screws..

[Dave]

don't need it, lugs will hold it on there fine. i don't know of anyshops that actually put them back in when rotors are done, they're a pain in the ass to get out next time anyway.

PB Blaster, 5 mm allen wrench. What is so hard about it?

[PeaveyBassist]

If its just hand tightened it should be purdy easy to loosen it by hand as well with the 5mm allen wrench.

Will

[DarkWing6]

Don't new ones come with the rotors? They came with mone. If not they cost like $.25 each. I know R3Vers are cheap, but come on guys.

[Charlie]

don't need it, lugs will hold it on there fine. i don't know of anyshops that actually put them back in when rotors are done, they're a pain in the ass to get out next time anyway.

PB Blaster, 5 mm allen wrench. What is so hard about it?

PFFFT.

Dremel and a flat head, no problems.

-Charlie

[rwh11385]

Replacements came with my brembo rotors. Used PB Blaster and had no issue. Put anti sieze on them before replacing. Help keep rotor on their so you can get your wheels on.

[Ryan Stewart]

Dude, new ones are bullshit. Ill sell you my used ones for 20 cents +shipping.

[rwh11385]

I have four used ones as well. $.15 each + shipping.