Hey all,
My car has a bunch of these circular connectors which are falling apart...
I'm looking for some advice on replacing the factory straight circular connectors:
61130007441 (small wire gauge .5-1mm) green
61130007442 (large wire gauge 1-2.5mm) green
The 90 degree ones are both readily available from FCP. 61130007441 can be had from Bimmerworld at $12.99 each.
So my questions is- what's everyone doing to replace these when they inevitably crumble into dust?
Are you guys biting the bullet on the $12.99 Bimmerworld remakes (if you only need the small ones), finding pigtails at junkyards/ebay, 3D printing new ones?
Would be awesome if there's a generic TE/Mouser part that's identical to these??
I'm hoping there's some hack that I'm just not considering- I wish I could convert all of these to Deutsch.
Any insight would be much appreciated!
My car has a bunch of these circular connectors which are falling apart...
I'm looking for some advice on replacing the factory straight circular connectors:
61130007441 (small wire gauge .5-1mm) green
61130007442 (large wire gauge 1-2.5mm) green
The 90 degree ones are both readily available from FCP. 61130007441 can be had from Bimmerworld at $12.99 each.
So my questions is- what's everyone doing to replace these when they inevitably crumble into dust?
Are you guys biting the bullet on the $12.99 Bimmerworld remakes (if you only need the small ones), finding pigtails at junkyards/ebay, 3D printing new ones?
Would be awesome if there's a generic TE/Mouser part that's identical to these??

I'm hoping there's some hack that I'm just not considering- I wish I could convert all of these to Deutsch.
Any insight would be much appreciated!
Comment