Looking for suggestions on custom parts to make and sell

[noid]

As an m20 guy I hate say this but, just go get a 24v motor.

Never give up on the struggle :hitler:

Tappet engine>hydraulic. The reason I want an 24v tappet head is the same reason I drive an E30 instead of a E90.

[e30onBBSs]

Some startecs/ mhw reps
working car phone
3 gauge pod as said before
louvers
r3vlimited valve cover?
cheap ITB's
24v head yess
universal bucket seat rails (not sure if possible lol)

[e30onBBSs]

Wait... Instead of doing a 5 lug swap, what if someone just made 5 lug wheel bearings..?? 5x100?

[kickinindian]

Wait... Instead of doing a 5 lug swap, what if someone just made 5 lug wheel bearings..?? 5x100?

http://www.r3vlimited.com/board/showthread.php?t=306268:wink:

[Kershaw]

Develop a bolt-on no-nonsense supercharger bracket for m10, m20, and/or m30.

http://www.bimmerforums.com/forum/showthread.php?2268017-Budget-E30-M40-Supercharger-Setups-Any-Intrest

[flyboyx]

Downing atlanta already makes an m42 sc kit. Afak its been available for many years.

[Fsnow]

Downing atlanta already makes an m42 sc kit. Afak its been available for many years.

The kit has been out of production for many years and used the m62 sc, was designed for the later m42 in the e36 iirc. Gkd sports cars made a kit but I think it was only for rhd and uses the m90 charger for the m42 although I think it was for the late m42 or m44. So no kit specific to early m42 in e30 has been produced AFAIK.

[Act of Congress]

Thanks everyone! I'm digging a lot of these ideas. Of course, feel free to keep posting and I'm going to retire to my shop and start tinkering now...

[noid]

You haven't answered what your capabilities are?

[Northern]

that depends entirely on your manufacturing abilities.

one thing that almost existed once but then didn't is a piece that bolts to the bottom of an E12 or E28 strut to adapt it to E30 control arms and tie rods. that would simplify 5-lug and large brake conversions considerably, since E28 struts are relatively easy to come by.

I like this.

[E30 Wagen]

A manifold for 24v swaps that will clear the stock booster, something like this:

http://s110.photobucket.com/user/dukhqan/media/intake2Medium.jpg.html

[Victell]

Make a m20 intake manifold to bolt a screw-type supercharger to the head.

Plus, leave space in the plenum to slide an air-water intercooler in there.

[Fsnow]

Thanks everyone! I'm digging a lot of these ideas. Of course, feel free to keep posting and I'm going to retire to my shop and start tinkering now...

So what exactly are your capabilities or thoughts on what you would actually like to make?

[czkb]

cheap:
s62 itb plate adapter for m60
equal length exhaust manifold for m60 in e30's