S52 finally!

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • parkerbink
    replied
    This was a hassle.

    As I need to run the O2 wire from the motor to the gauge for my PSB-1 I looked for a passthrough, finding nothing, I searched for 20+ minutes, closest I came was a thread on Bimmerforums with derision over asking where the firewall was.

    I am pretty sure had my interior not been gutted I would not have found this, passenger (right) side (US car) it exits behind the aux air pump.

    I also need to run 2 wires to get the oil & water temp data to the gauges.



    Leave a comment:


  • parkerbink
    replied
    This literally kept me up last night worrying that I would not get it in/get the wires where they needed to be.






    Last edited by parkerbink; 12-28-2023, 10:44 AM.

    Leave a comment:


  • 2mAn
    replied
    Can’t wait to see it with the new interior!

    Leave a comment:


  • parkerbink
    replied
    M Roadster hard rubber differential bushing.

    Leave a comment:


  • parkerbink
    replied
    Turned out the heater core needs to come out to "properly" r&r the rug. No.

    Exhausted, need to figure out the best way to cut the "new" carpet to get it in.






    Had to pull, push, pry & cut the rug out, these were the tools.

    Leave a comment:


  • parkerbink
    replied
    Slowly disassembling the interior, all that remains are passenger under dash, dash & carpet.



    Proof of concept on the amp complete.



    Leave a comment:


  • parkerbink
    replied
    It has begun.....



    Ran the remote turn on for the sub amp & RCAs to the trunk.

    Leave a comment:


  • parkerbink
    replied
    Got the 90 degree hose, cut it down & got it pretty well together.



    Leave a comment:


  • parkerbink
    replied
    Black plastics cleaned & ready. Waiting for blue sun visors & a header panel that goes under the sunvisors across the inside top of the windshield.




    Leave a comment:


  • parkerbink
    replied
    I like my fog lights but to fit the air filter the driver side had to go, not having one so these went in.

    Thanks 2mAn for the vents!


    Leave a comment:


  • parkerbink
    replied
    Last piece of the puzzle, carpet came!



    SC fully tucked in & finally good, now comes the remote tuning. Still need to install the PSB-1.


    Leave a comment:


  • parkerbink
    replied
    Dialing it in & getting the the hood to close & run properly is an adventure, attempt #5, not running right yet.




    Dash & the rest of the black interior parts (except carpet) came.



    Leave a comment:


  • ZEKTI
    replied
    Great thread! Just in time for that sweet boost weather.

    Leave a comment:


  • parkerbink
    replied
    It's done!


    Leave a comment:


  • Panici
    replied
    That exhaust looks great there! Let's hear it.

    Leave a comment:

Working...