2nd e30, 87 Lachssilber Revival

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • mmoyer11
    Wrencher
    • May 2015
    • 206

    #421
    This is so sick that you're still working on this car 10+ years later....love it.

    Comment

    • Reichart12
      R3VLimited
      • Aug 2012
      • 2166

      #422
      Originally posted by mmoyer11
      This is so sick that you're still working on this car 10+ years later....love it.
      It's been so long now I'm very much committed to this e30 in particular.

      Instagram: Reichart12

      Comment

      • mmoyer11
        Wrencher
        • May 2015
        • 206

        #423
        Originally posted by Reichart12

        It's been so long now I'm very much committed to this e30 in particular.
        Amazing dedication and awesome car!! I just Hit 10 years with my 90’ Sedan. Wish I had documented the process more.

        Comment

        • Reichart12
          R3VLimited
          • Aug 2012
          • 2166

          #424
          Looking for some advice on replacement parts for the fuel/evaporation system... there are two plastic tubes that run from the gas tank to the evaporation tank in the right rear wheel well. I need to replace these but can't find any production parts. Can I just use fuel injection line that I have on hand that are the same sizing? Feels like overkill for what I'm replacing but easy enough if it's on hand already.

          Instagram: Reichart12

          Comment

          • 2mAn
            Señior Mod
            • Aug 2010
            • 21075

            #425
            Id look to see what other evap hoses are available from BMW, Im sure they didnt rewrite the book on them... though I think you should definitely start putting the car back together
            Simon
            Current Cars:
            -1966 Blue Boat
            -1969 Red VW
            -1986 White BMW
            -2006 Green Thing

            Make R3V Great Again -2020

            Comment

            • digger
              R3V OG
              • Nov 2005
              • 6210

              #426
              i just replaced mine with new plastic lines a couple weeks ago, hoses probably wont fit and will be hard to feed through but hard lines should but i think the metal tube has some curvature to it which might make it harder to feed them in and the flexibility of the plastic is very helpful for routing behind the metal cover. Tbh mine could have gone another few decades but until you pull them out it is hard to know

              Also for anyone doing this job realoem says all hoses are 8x13 but there is some small sections of 6x11 for the evap system that connect to the smaller of the two plastic tubes
              89 E30 325is Lachs Silber - currently M20B31, M20B33 in the works, stroked to the hilt...

              new build thread http://www.r3vlimited.com/board/showthread.php?t=317505

              Comment

              Working...