87' Delphin 325is LS1: Went to Paint

[Snou52]

Hmm...what are you gonna do with all that turbo stuff? ;)

hahahah EXACTLY! :D

[Rc 415]

First peeks inside look good!

[Rc 415]

Moving along, driveshaft modded and ready for install


Oil pan patch bent ready for welding



Water pump pulley pulled out 3/8" and tack welded so it won't move

Mustang gt hydro boost

[Rc 415]

Hydro boost n shit all modded ready to go

[JFarhanbod]

damn you are doing work

[Rc 415]

Got me a late model valance to put on the rear of my car:

[Rc 415]

Oil pan is ready for some bead laying

[Cronopoulos]

Awesome progress, this makes me happy.

[Rc 415]

Got me a set of headers

[Rc 415]

Got me a set of headers

[Rc 415]

Beaded up the pan







Got the correct headers



Ordered steering shaft solution


Got my wiring and relay/fuse setup




Shot of the corner where I'm stacking everything up

You can see the new rad behind the trans there too

[garretvs]

Nice work! Keep it up with pics

[Rc 415]

Will do, your guide is great and the parts you made are high quality as well! Do you think I can fit 3" pipe from the headers? I wont be running cats, and I noticed 3" pipe fits pretty nice through the trans brace. I want to run 3" from each header to a 4" oval exhaust with a cutout or something. Also there are some parts that are missing in your master parts list that I found while reading though each section.

[Rc 415]

Starting the cam swap. I decided to go with a Texas Speed & Performance 228r cam, beehive springs and chromoly pushrods. Good for a 50hp gain.






This engine is so clean inside it's Crazy!

[Rc 415]