I really wanted this post to be an update with the shifter installed but I hit a small roadblock yesterday; getting to the bitch clip...
I've already removed the trans brace and also removed the nuts and bolts that attach the giubo to the driveshaft to allow the tranny to tilt and get some angle but the tranny isn't moving.
Do I need to remove all 6 of the nuts and bolts on the giubo, or should I loosen the motor mounts? Any other tips?
I'll be heading to Harbor Freight today to confirm if the tool mentioned in the DIY is NLA. A new HF just opened by my house so it's not a huge waste of time to go there.
I've already removed the trans brace and also removed the nuts and bolts that attach the giubo to the driveshaft to allow the tranny to tilt and get some angle but the tranny isn't moving.
Do I need to remove all 6 of the nuts and bolts on the giubo, or should I loosen the motor mounts? Any other tips?
I'll be heading to Harbor Freight today to confirm if the tool mentioned in the DIY is NLA. A new HF just opened by my house so it's not a huge waste of time to go there.
Comment