Melon's E30 Build.

[Melon]

Got some photos from the shop, they had to do some work to get one half shaft out.











Sent from my Pixel 2 using Tapatalk

[majdomo]

As soon as I can!

Waiting on the shop to finish up my rear end.

Sent from my Pixel 2 using Tapatalk

Probably sorta important. :) Looking good, Louis!


Sent from my iPhone using Tapatalk

[Melon]

I only put two coats of clear on it, and in some places it's a bit thin. I'm considering taking it to a professional detailer and seeing what they think, but I have no false hopes.

This was my first paint job, so lesson learned. Also, this car was always meant to be a driver, it was never meant to be a show queen.

[Jokester]

Finished for the weekend, got the vent window latches in, all grab handles and the washer nozzles on the hood. Skeet skeet!



Sent from my Pixel 2 using Tapatalk

Please tell me you’re going to wet sand the car. Too much work has been done to leave a finish like that.

[Melon]

Finished for the weekend, got the vent window latches in, all grab handles and the washer nozzles on the hood. Skeet skeet!



Sent from my Pixel 2 using Tapatalk

[Melon]

What rotors are those? Look pretty sweet

UUC BBK

It's not bad, but if I were to do it again, I'd go with something from Massive Lee.

Sent from my Pixel 2 using Tapatalk

[Melon]

Sweet!!! When do you plan to take out for a spin??


Sent from my iPhone using Tapatalk

As soon as I can!

Waiting on the shop to finish up my rear end.

Sent from my Pixel 2 using Tapatalk

[Albie325]

What rotors are those? Look pretty sweet

[majdomo]

Sweet!!! When do you plan to take out for a spin??


Sent from my iPhone using Tapatalk

[Melon]

Hood on!



Sent from my Pixel 2 using Tapatalk

[Melon]

Painted the rear calipers.

Re did the vacuum lines to the charcoal canister.









Sent from my Pixel 2 using Tapatalk

[Melon]

Booster gasket installed, used some foam I had.

So, I thought I didn't install the gasket between the master cylinder and the brake booster, turns out I did and it slipped inside the booster somehow, so glad I decided to do this.

It's a bit folly, the grommet for the clutch master cylinder line can leak.

I'll wait and see.

[Melon]

that only works if there is only one in there :)

I only had one, but wanted to clean and inspect the sides of the sealing surface, so out it came, and what a fucking bitch to get out.

[zaq123]

When replacing the selector shaft seal - don't remove the old one. Just put the new one right over top of the original.

that only works if there is only one in there :)

[nando]

When replacing the selector shaft seal - don't remove the old one. Just put the new one right over top of the original.