What did you do to your E30 today?

[Narsiyousif]

[Narsiyousif]

[Narsiyousif]

[Stan]

very low tech, installed Laminex on my headlights and fog lamp lenses.

[Narsiyousif]

easy modification to the headlight

[jhaurimn]

Replaced rear trunk shock and adjusted the trunk to be flush when closed. With a new shock installed there was upward pressure on the drivers side that pushed the trunk up just a little bit. Adjusted the center bracket thingy to bring the trunk down a tad more when shut. Its so weird having the trunk pop open now when I press the button to open it.

Looks like this person hasnt been active since May, I will try PM'ing them but does anyone understand what was done to fix this?

[808ETA]

Finally got around to adding sound deadener.

How is the sound deadening? Is there a noticeable difference?

[sdfe30]

Finally started getting some parts in for my late model 318. This was the first to show up, other than the poly bushings, which I'm waiting on new suspension components to do.



Of all the parts on order, this was the first to come in. The console was detailed immediately after this, so don't worry about the grime.

Incoming:

z3 rack with garagistic kit
Garagistic Offset FCA bushings
Koni Orange and H&R sports all around
e90 top hats
new front shock mounts/bearings
Garagistic rear subframe and diff bushings
Rear wheel bearings
Mtech 1 Steering wheel

[strickland]

Finally got around to adding sound deadener.

[prisonerofdoom83]

Got bored got custom with it

[TeXJ]

yesterday, installed the tuner coolant temp sensor(OBD2) and the splitter for the obd1 signals. I'm obd1 swapped and the sensor was in the head was a obd1 sensor and would need to be rethreaded to fit the obd2 head.

[roguetoaster]

Changed the cam sensor seal, replaced the driver's sill trim, and repainted the lower exterior trim.

[Joe_Nycalive]

Swapped my bolts to studs but found out my rear spindles are shot so now have to replace my spindles So much fun

[quasi mofo]

Howd you attach that?

The ring at the bottom of the knob has set screws you use to secure the knob to the shifter rod.

I made a custom order with Built by Basil.

https://builtbybasil.com/

[amcp]

Howd you attach that?