Announcement

Collapse
No announcement yet.

NOR-CAL General Chat.

Collapse
This is a sticky topic.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    where do all the hip youths buy 5x120 adapters these days? they don't seem to be in stock on the adaptec site..
    cars beep boop

    Comment


      When I ordered mine, I called and spoke with Jr. He seemed to know the BMW wheels and fitments to my application (e38 Style 5's to my E30). That's probably better than ordering online if you need something more specific.
      - 98 M3 Cabrio
      Photo work: http://www.herbreal.com
      Instagram: @herbreal
      Twitter:the_herb_real

      Comment


        well I know I need the thinnest ones available.. and a healthy roll ;)
        cars beep boop

        Comment


          dont get any that are thinner than 18mm

          Much wow
          I hate 4 doors

          Comment


            What wheels were you planning on putting on your car? I assume its for your euro e30? (looks fantastic btw). I know the typical style 5 application for the said wheel combo was 18mm front and 20mm rear and "mild rolling" meaning, no pulling and you can roll the fender not past the dimples. hope that helps.
            - 98 M3 Cabrio
            Photo work: http://www.herbreal.com
            Instagram: @herbreal
            Twitter:the_herb_real

            Comment


              16x8 et25 rears, 16x7 et13 fronts
              cars beep boop

              Comment


                make sure you measure a few times to see that the caliper will not contact the rim
                Much wow
                I hate 4 doors

                Comment


                  i think with ~18mm spacers that won't be an issue.
                  cars beep boop

                  Comment


                    You should be fine, see if you could go as low as 15mm on the fronts since your final offset will be 16x7 -5 on the front (with the 18mm spacer) may stick out too far.
                    - 98 M3 Cabrio
                    Photo work: http://www.herbreal.com
                    Instagram: @herbreal
                    Twitter:the_herb_real

                    Comment


                      there are no 15mm 5x120 adapters out there..
                      cars beep boop

                      Comment


                        I think the lowest offset you can go without considerable poke is +5 (regarding that x7 in the front). Got camber plates?
                        sigpic

                        Always chasin'

                        Comment


                          yeah I've got camber plates. need to re-verify the wheel measurements, but mystikal suggests 195s on the front, which is wimpy :(
                          cars beep boop

                          Comment




                            Someone should go check out that speedster just for giggles :rofl:

                            Comment


                              Unless you request otherwise that thread is very fitment/flush oriented. What's the point of running cool wheels if you're going to wrap them in rubber bands? I'm sure 195s would fit with that low offset and 3+ degrees of camber, but it would look silly (obviously just my opinion, don't get butthurt stance folks), not to mention the roads around here suck, you'd bend the lips in short order with them waffleswaffleswaffleswaffleswaffles tires.
                              sigpic

                              Always chasin'

                              Comment


                                grossss

                                Comment

                                Working...
                                X