NOR-CAL General Chat.

[decay]

you dont make them spin backwards :rofl: just turn it around for push or pull.

you wouldn't be able to do that with the one i got- it's only meant to mount one way.

[JinormusJ]

Any of you gays wanna come help me swap my engine :firehop:



I have hot dogs




and Cup-of-Noodles

[golde30]

Car was bogging extremely bad then dieing after a few seconds after start up. Went back to the car to start it and now runs perfectly fine. can this be a vaccume leak? bad Cam sensor? TPS? If the cam sensor was bad would the car even start?

Check you ground wires. I had this problem with my old 325is, turned out to be loose ground on battery...

[E30_Pare]

check you ground wires. I had this problem with my old 325is, turned out to be loose ground on battery...

+1

[Vivek]

you dont make them spin backwards :rofl: just turn it around for push or pull.

You can't really do that, they're not slim fans so there's a big ass motor sticking out the front. Decay, I'll try running it with just the e30 aux fan. I'll just have to plug in the fan like normal and switch the sensor on the radiator to an e36 one right? I may get a colder thermostat too.

[Cabriolet]

LBV just buy a real fan or go back to mechanical.

[E30_Pare]

But mechanical robs powwa!


Sent from my iPhone using Tapatalk

[Cabriolet]

But mechanical robs powwa!

this is how you know your engine is too damn small. if you care about 1hp, time for a real engine

[YosemiteSam]

So my car decided I shouldn't drive it to class. It is inconsistently refusing to rev. One time I'll hit the gas and it will be fine, but the next time I hit the gas it ill not go above 1k rpm. I'm thinking TPS. What do you guys think?

[kronus]

TPS is just switches for idle and WOT, it shouldn't affect that. Check if your AFM flap is binding.

[Cabriolet]

bad KPS

[YosemiteSam]

TPS is just switches for idle and WOT, it shouldn't affect that. Check if your AFM flap is binding.

Ah, I didn't know that. I'll check that when I get home.

Edit- What's a KPS Eric?

[Cabriolet]

Crank position sensor

[YosemiteSam]

Ah. That wouldn't be easy to replace, would it?

[Cabriolet]

Ah. That wouldn't be easy to replace, would it?

easy as pie. cost is the issue. but i haz an extra