Pulled the head and came. They are in great shape. #2 piston is sitting 6-7mm lower than the rest. Apparently I was making to much power for the forged K1 H beam rods. Hope to pull the motor tomorrow and lay the rods on the bench I have a feeling the bend is significant.
Turbo time for my S50 on a "budget"
Collapse
X
-
-
It reminds me of that college question
What is the fastest way between any two points on the face of the earth...........
a curved line, a zig zag or a straight line. Lots of people say a straight line but the earth is curved. HAHA.
Given that it has dropped I could drag out some old geometry and trig and figure out the arc before I pull the bottom end but at this point its safe to say that its bad.1989 332IS -S-Fiddy Four-Some weight removed.
5 lug E36 M3 Brakes Coilovers and LTW's and No ABS.Comment
-
So are you replacing rods and keeping the turbo setup?
1991 LS1 Swapped 318is
Instagram:
https://instagram.com/saltybeast/
LS Build Thread:
https://www.r3vlimited.com/board/for...s-e30-ls1-swapComment
-
Comment
-
Comment
-
Yeah, google did confirm that. I wonder how their failure rate compares to others. Was it predetonation that caused this?
Megasquirt plug and play is sounding better and better.sigpic
Gun control means using both hands
Sex, Drugs, Rock 'n roll. Pick two.Comment
-
1989 332IS -S-Fiddy Four-Some weight removed.
5 lug E36 M3 Brakes Coilovers and LTW's and No ABS.Comment
-
So just gross material failure? No evidence of hydrolock...sigpic
Gun control means using both hands
Sex, Drugs, Rock 'n roll. Pick two.Comment
Comment