If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I am brand new to this forum and have been reading numerous threads on how to get all four headlights to work when on highbeam. I just bought a 1990 325is and the PO installed US ellipsoids. I would like to know how to bridge relays from k2 to k3 using # 30 terminals. Is it just a wire soldered to each hole? How does the relay fit back in the slot using this method? Is there any easier method?
Comment