Mark the driveshaft / output shaft or tire and rotate. Should be ~ 3 3/4's or a little over 4 turns to determine your gear ratio.
Announcement
Collapse
No announcement yet.
RTV Gasket Sealer on Intake Manifold Gaskets?
Collapse
X
-
make sure you have the washers and spring in the right configuration on the bitch tubeSeat Shocks....I have passed the baton to John Christy from Ninestitch. Email John or Garrett at ninestitch1@gmail.com
https://www.r3vlimited.com/board/sho...86#post4944786
Alice the Time Capsule
http://www.r3vlimited.com/board/showthread.php?t=360504
87 Zinno Cabrio barn find 98k and still smells like a barn. Build thread http://www.r3vlimited.com/board/show...20#post3455220
Comment
-
Originally posted by redlightpete View PostRegarding your 3.73, when I refreshed mine, the pinion bearings were completely worn out and loud. The other bearings were ok. Might want to at least inspect them while you’re in there.
Comment
-
I measured everything carefully, and the replacement bearings were the same thickness, so I didn’t end up changing any shims. I just set the preload with a new crush sleeve and checked it with paint.
If you just disassemble the pinion to check the bearings, you’d only need to redo the crush sleeve and preload.
Comment
-
my throttle body flange warped so i had to file it down flat again.
Didn't try to polishing it out, just filed it flat and i used gasgacinch. very good sealant.
normally i just copper spray every single paper gasket though. even the metal exhaust gaskets.
head gasket. metal turbo gasket. even if ur engine is stock another level of 'just in case' is good.
Comment
-
I'm still trying to figure out how one warps a throttle bodySeat Shocks....I have passed the baton to John Christy from Ninestitch. Email John or Garrett at ninestitch1@gmail.com
https://www.r3vlimited.com/board/sho...86#post4944786
Alice the Time Capsule
http://www.r3vlimited.com/board/showthread.php?t=360504
87 Zinno Cabrio barn find 98k and still smells like a barn. Build thread http://www.r3vlimited.com/board/show...20#post3455220
Comment
-
Originally posted by LowR3V'in View Post^a different flange welded on it. got too hot.Seat Shocks....I have passed the baton to John Christy from Ninestitch. Email John or Garrett at ninestitch1@gmail.com
https://www.r3vlimited.com/board/sho...86#post4944786
Alice the Time Capsule
http://www.r3vlimited.com/board/showthread.php?t=360504
87 Zinno Cabrio barn find 98k and still smells like a barn. Build thread http://www.r3vlimited.com/board/show...20#post3455220
Comment
-
Originally posted by LowR3V'in View Postmy throttle body flange warped so i had to file it down flat again.
Didn't try to polishing it out, just filed it flat and i used gasgacinch. very good sealant.
normally i just copper spray every single paper gasket though. even the metal exhaust gaskets.
head gasket. metal turbo gasket. even if ur engine is stock another level of 'just in case' is good.
Sent from my XT1064 using Tapatalk(OO=[][]=OO) For Life
Comment
Comment