If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I thought I had read some people were seeing low 20's in stock form in an E30.
What? No way man, maybe an M10. My 325ic ran a 14.7 1/4 with 15" weaves and a JimC with a 4.10 lsd rear end. Does anyone else have any track times, Gtec 0-60 or 1/4's, or dyno sheets to share?
back to the d´sylva chip subject, their website is not very informative in that matter. It only claims to allow the engine to rev up to 6.8K. Does not mention speed limit removed or hp gains.
What about Jim Conforti (turner) ?
and eBay? I kinda know what you´re going to say "you get what you pay for..."
In this type of upgrade I can only think of them as "works as advertised" ....or doesn´t....maybe someone tried them with good results.
back to the d´sylva chip subject, their website is not very informative in that matter. It only claims to allow the engine to rev up to 6.8K. Does not mention speed limit removed or hp gains.
What about Jim Conforti (turner) ?
and eBay? I kinda know what you´re going to say "you get what you pay for..."
In this type of upgrade I can only think of them as "works as advertised" ....or doesn´t....maybe someone tried them with good results.
i highly recommend mark d'sylva. if his site is lacking, trust me it's just the site, not his chips or knowledge. i like his chip the best of any on an m20. conforti would also be fine. lurk around m30-powered car forums to see what those guys are running.
Comment