A look at things to come

[Matt-B]

I don't know about correct, just the easiest. I just shortened mine.

its the OEM linkage for mating a 240 to an m20, so by default I would think Its the best solution and most correct :)

got a pilot bearing today, my new washer tank for steal mode coin tray and my new 4 M badges for seats

[ahriley91]

its the OEM linkage for mating a 240 to an m20, so by default I would think Its the best solution and most correct :)

got a pilot bearing today, my new washer tank for steal mode coin tray and my new 4 M badges for seats

It is the best solution, I just had access to a welder and got it done. I was too impatient. haha. And I love your attention to detail. It all looks really good. I wish I hadn't been so impatient. lolz

[Matt-B]

my master all painted and done...



Fly just chilling ( rust is gone)


Clutch n' shit chilling

[Wishno87]

Lol everything is just handin out in harmony huh? Put those studs in before you nearly kill yourself again

[Matt-B]

lots of work to be done tomorrow :)

[Matt-B]

intake boot valve, fly bolts, fly spacer, oil pan plug

[Matt-B]

cut all brackets off in engine bay, will probably remove ABS, more insulation tomorrow


I stripped 1 brake line, so Im going to get brake line tools as well

[Matt-B]

bondo on most seemd

got primer and ordered the paint for engine bay, its white but not glossy

[Jand3rson]

bondo on most seemd

got primer and ordered the paint for engine bay, its white but not glossy

Flat white in the engine bay? Man, every time anything even remotely dirty touches it, you're going to get a mark that probably won't rub off...

[Wishno87]

Flat white in the engine bay? Man, every time anything even remotely dirty touches it, you're going to get a mark that probably won't rub off...

+1 it Is going to be nasty. Matt remember when we painted your old car flat white?

[Jand3rson]

+1 it Is going to be nasty. Matt remember when we painted your old car flat white?

There's a kid here that painted his E30 flat white, and after a couple of weeks, it looked like absolute shit, nothing that can be done about it.

[Matt-B]

Its not like a flat or gloss paint, its a rough paint...I could not seem to decide on a spary paint so i got this



Im promise Im not posting to post, added loop connectors and wired alternator

added the safety valve for coolant, which Janderson will be doing, As I instructed him...

took e34 wire holder off, and wrapped the harness with tape, will use cloth tape on it tomorrow.

Bondo on, sanding tomorrow, primer tomorrow. Pleased its been 60 degrees outside

[Wishno87]

Please its been 6

huh?

You get my PM?

[Jand3rson]

What is that intake boot valve you ordered, and which coolant safety valve are you talking about?

[Wishno87]

Matt why did you paint the master cyl? If you get so much as one drop of brake fluid on it that stuff will just melt off

It would probably look just as nice if you cleaned it up a bit.