A look at things to come

[Van Westervelt]

Skin and bones are intact. Thats a superficial injury. Get back to work.

[accident]

looks like rug burn to me.

[ck_taft325is]

looks like rug burn to me.

Bwaahahahahahaha.

[DREWHALL]

Got lucky.

[Jand3rson]

Thanks JT, there is a reason i posted it on FB, so people dont think Im a complete retard, and think I dont know what Im doing. The fault was the chain, not me

Don't sweat it Matt, we all think you're a complete retard already.

:D

Shit happens man, you get hurt. You walk it off, and get back to work.

[AndrewBird]

Its was really purple and green, and those dark red spots were bleeding, I could barely walk after it happened

That's why you NEVER put yourself under something hanging from a lift. Kind of like how you never get under a car only supported by a jack.

[Matt-B]

I was in my office chair doing tranny seals...it swung and got me...

I need to buy a 30mm deep socket, and no one has them

[ck_taft325is]

I was in my office chair doing tranny seals...it swung and got me...

I need to buy a 30mm deep socket, and no one has them

Look at axel/hub removal sockets. They come in a good variety and are usually plenty deep for most anything you need to do. The only issue I've run into is that the sidewalls are sometimes a bit too thick.

[Matt-B]

Yea, im thinking impacts to, for the rear seal on trans

[Simon S]

Bavarian Autosport has the socket you need.

Tools/Output flange nut tool.

Fuckin total pisser though on how ass-raping expensive it is..
($50 tool to replace $2 seal. Ug ! )

Found it on Pelican's site also - for a few dollars cheaper.

[DTM190]

Or,

You can get a short 30mm and get an old socket and weld them together, what I did. If you weren't 45345345kms away I would lend it to you.

[Matt-B]

hmmmm, i might do that

[glucklich21]

Advanced Auto Parts sells a 30mm that fits.

This is the one I used for this job:

http://shop.advanceautoparts.com/webapp/wcs/stores/servlet/product_1-2%22-Drive-12-Point-Deep-Socket-30-mm-Gear-Wrench_25984184-P_N3408J_T|GRP2062_____

Just make sure it's that PN, not the normal 30mm. Should be something like 8 bucks. ;)

[Wishno87]

I have one you can borrow if you can promise me you will bring it back within a reasonable amount of time.

[Matt-B]

Ill borrow it tomorrow, thanks