First OFFICIAL TWINCHARGED M20 BUILD

[Denny]

***Update***

had a little bit of time tonight to work on the beast.

Installed my 60# injectors and uploaded "Kamators" super turbo tune as a starter to my twincharged setup so I can street tune right away...thanks for the deal :)

Didn't have time to start the car up to test as its too late don't want to wake the neighbors LOL...

Last but not least I want to install my ARP head studs too.

[Mr. Tasty]

I iz sad.

[Denny]

I iz sad.

***update***

Few more things done.


DEKA 60# injectors are now installed along with a good starter tune from "Kamotors" the car started right up but was very lean so I will have to tune tune it from scratch basically my engine has a lot more airflow because of the supercharger. I got the car to idle at around 13.9-14.5AFR at 1350RPM so far.


I also finished the day with my ARP headbolt studs to 60# torque...tomorrow I will bring the engine to temp and let her cool down a bit and retorque final to 65-70# torque.

Getting very excited to start driving her... road insurance starts on may 1st :)

* Please ignore the pathetic little K&N filter...LOL... they sent me the wrong one and I refuse to use the chinese one I bought that I found loose mesh inside..

[LJ851]

Oh hell yes.

Work faster !

[goarmy]

so what will you do for traction

[Denny]

I iz sad.

Oh hell yes.

Work faster !

:) Wish I could!! Family life...

so what will you do for traction

Very good question...Slicks for the track for sure...and on the street well I'm hoping my rear 16x9 ESM's and 225/50's will be ok for a while... I may go the 17"x10 XXR 526's with 265's route if It doesnt hookup

[Peattie]

:) Wish I could!! Family life...


I may go the 17"x10 XXR 526's with 265's route if It doesnt hookup

Im liking the way you think :up:

[Denny]

Im liking the way you think :up:

and I like the way U think too ;-)

Did you have to get rings for the center bore?

[Peattie]

and I like the way U think too ;-)

Did you have to get rings for the center bore?

not that I know of. Kam hasnt told me I needed any so I guess it bolts up no problems

[kamotors]

Your old ugly ricer rims have hub rings so you don't need any^

[Denny]

Im liking the way you think :up:

Your old ugly ricer rims have hub rings so you don't need any^

LOL... but I will need some. How much do they go for?

**small Update **

Got the ARP final torqued at 70 pounds this morning. Car sounds really good...expect I cant bring my idle down more the 1400 rpm :(

[kamotors]

LOL... but I will need some. How much do they go for?

**small Update **

Got the ARP final torqued at 70 pounds this morning. Car sounds really good...expect I cant bring my idle down more the 1400 rpm :(

richen it up and it should drop it down,are you adjusting the Idle PWM duty table?

[Denny]

richen it up and it should drop it down,are you adjusting the Idle PWM duty table?

leaner and richer didnt change much. Im still a newb to MSII what does the Idle PWM duty table work? and what changes should I be doing?

[Denny]

time to start tuning.....made these smooth starter maps.

[whodwho]

Pics aren't showing but typically you will have higher advance at cruise loads(~35-40), light loads and leaner mixes need more time ;)