S38 turbo e30 Hartge H35-24 H bomb

[2mAn]

The French Yellow lights look fantastic against the black.

[e30m3s54turbo]

The French Yellow lights look fantastic against the black.

I seen a blk e30 m3 with Frenchy yellow lights. I been wanting to add them to my m e30.

I didn’t add these to the red m e30. I added this to the clear fog lights with yellow flim.

[e30m3s54turbo]

I bought a couple tweeters for the red car and few speaker pods for e30. I didn’t like how they were sitting with after market pods. I will place them on top of 5.25 speakers. I will order new bmw pods.

I also bought H&R 25mm spacers for the blk m car for the front. I didn’t like how far they sat. I had a few wheel spacer like 15mm spacers. I like how far it sat. I bought new 15mm spacer with bolts.

[e30m3s54turbo]

I finally got e90 hats on blk m car. I have hade them for more that 10 years laying around. I bought 15mm spacers for front suspension. When I started to pull sturts off to add e90 hats. I tested my e36 m3 front calipers on my e30 m3 sturt. They bolted up. I am going to order a 12mm spacer to fit between hub and rotor.
I’m going use e36 m3 front and rear brakes and rotors plus e36 m3 parking brake pads. I took a pick of my 27 year old H&R racing springs.
I love how the blk m car handles with H&R and Beilstein,’s plus camber plates.

[e30m3s54turbo]

I worked on hood hinges to lighten up the front. I saw an other member do this to track car Moatilliata. I was able to get hinges and hood linkage a pound. I will be ordering a Karbonius carbon fiber hood that weighs 12lbs. The factory hood weighs 44lbs. This e30 is street car. I wanted to shave weight off the front as possible. The carbo hood, hinges and ABS unit is 43lbs. For now Im good. The front bumper weighs a lot.

[2mAn]

I worked on hood hinges to lighten up the front. I saw an other member do this to track car Moatilliata. I was able to get hinges and hood linkage a pound. I will be ordering a Karbonius carbon fiber hood that weighs 12lbs. The factory hood weighs 44lbs. This e30 is street car. I wanted to shave weight off the front as possible. The carbo hood, hinges and ABS unit is 43lbs. For now Im good. The front bumper weighs a lot.

That hood hinge looks amazing! How hard was it to drill it out so much!?!

[e30m3s54turbo]

That hood hinge looks amazing! How hard was it to drill it out so much!?!

Hi Simon.

It was not hard it took time line up measurements. If you have a drill press it would be more easier. Of course I didn’t. My buddy said I need a drill press. I used 3/4 washers line up on my 1” blue tape. I measured around to mark in to 1/4” I would transfer my tape 180 degrees to line up my punched hole to drill with a small drill bit.

[e30m3s54turbo]

I finally finished my fourth wheel with new chrome OZ bolts. I did break my OZ socket. I will need to order a other set.
I bought an other under tray. The old was falling apart. I like these because they are made of plastic. I will be buying a couple more for other projects.