S38 turbo e30 Hartge H35-24 H bomb
Collapse
X
-
Cant wait to see these installed... is 2027 the year we will see it at SoCal Vintage show?? -
-
-
-
-
-
This weekend wet sanded Blk bumpers. The trim was an other story.
I has to sand down the front ends. I bought these years ago. Where I bought them don’t remember. Next time I will buy in Europe. I didn’t want to paint flat blk. The ends were not perfect and small scratches. I painted them. After adding clear they looked grey to me. I’m going to sand them to paint gloss paint and spray clear.
Leave a comment:
-
-
I’m still waiting on parts to come back from zinc coating. I’m still prepping the silver e30. I’m going to paint the hood, rear Hartge apron and trunk separately. I’m going to paint the plastic bumpers black. That should make it easier to paint. I forgot I pull the Hartge wing off. It was a bitch get the rusty bolts off. I had to drill them off.
Leave a comment:
-
-
I spoke to Mario that owns a shop that zinc plates, polish aluminum and chrome. He said he can dip is rust removal and bead plast the rust off. I wired brush the rust off the rear calipers. On the rears I toured them down. On the fronts I left the piston and plugged the other holes. I’m thinking of putting back the rear pistons to zinc plate then.
Has anyone done zinc this on their calipers?
I been ordering more parts for the e36 m3 brakes on my blk m car.
The rotors will be new.
👍 1Leave a comment:
-
I drilled the shit out of hung to see how I could lighten it up. I did like how much it weighted. I ordered some aluminum 3/8 thick on eBay. The sent a 1/4 thick. I traced it and cut to shape. I polished it up and drilled a few holes. I was able to get more than half of the stock weight.
I could not find my other rear set e36 m3 calipers. I some rusted rear e36 m3 calipers. I toke them apart to wire brush them. I called the zink and chrome shop if they could sink plate them front and rear. He said yes. I ordered the new pistons and rubber seals.
🥰 1Leave a comment:
-
-
Hi Simon.
It was not hard it took time line up measurements. If you have a drill press it would be more easier. Of course I didn’t. My buddy said I need a drill press. I used 3/4 washers line up on my 1” blue tape. I measured around to mark in to 1/4” I would transfer my tape 180 degrees to line up my punched hole to drill with a small drill bit.
👍 1Leave a comment:

Leave a comment: