What did you do to your E30 today?

[goldenE30]

R134a conversion finished yesterday
Replaced compressor and both lines, evaporator, expansion valve, condenser and receiver drier with new pressure switch!




Sent from my iPhone using Tapatalk

[TeXJ]

Got this done last sat. Ebay long tubes, ebay 2.75" inlet dual 3" outlet exhaust, no cat

https://youtu.be/_cwJmq36evU

[MrBurgundy]

Front brakes and wanted to address a slight coolant leak at the TB. Turned out to be a project, of course.

Two of the three screws broke off







A little sandblasting



Tried to torch it and use some vice grips to break it free, but that didn’t work out.



Then, I ghetto welded a nut to the rest of the screw with brass





Oh em geee, Yay!






Sent from my iPhone using Tapatalk

[88BlackS-ETA]

Passed state safety inspection and was emissions exempt again, only put on 1,064 miles over the last year sadly, so Im now at 108,613 miles. I plan on driving it like crazy this year but stay under 5,000 miles so Im emissions exempt.

[htseng]

New shifter and ebrake leather boots. Oil and filter change


Sent from my iPhone using Tapatalk

[jgilber0]

Changed fuel feed, return, and canister vent lines in the engine compartment. Lots of stuck hose clamps; took forever.

Oil change with Castrol 20W50 and a Mann filter.

Changed the oil level sender; stupid red LED still on in the overhead check panel after.

Adjusted alternator belt tension.

Somewhat frustrating day.

[jgilber0]

Changed fuel feed, return, and canister vent lines in the engine compartment. Lots of stuck hose clamps; took forever.

Oil change with Castrol 20W50 and a Mann filter.

Changed the oil level sender; stupid red LED still on in the overhead check panel after.

Adjusted alternator belt tension.

Somewhat frustrating day.

Even more annoying- tension on alternator belt is now too tight. Was too loose before.

[IRON-E]

Stared at it.

[jgilber0]

Progress!

Finally got the alternator belt tensioned properly.

Replaced the valve cover vent line - completely brittle. Broke on removal.

Replaced most of the vacuum line for the brake booster, resolving a leak at the check valve/intake boot junction. Ran out of good hose clamps – used some crappy old clamps lying around. Will replace later with nice OEM parts.

Idle is finally settling down into a nice cadence again as I eliminate the vacuum leaks.

Put my son in the front seat, drove to the gas station and filled up with a tank of 90 octane no-ethanol Shell.

On the way my low oil light finally went out in the indicator panel! Took about 5 miles for the new oil level sender to start working. Weird.

[jeenyus]

On the way my low oil light finally went out in the indicator panel! Took about 5 miles for the new oil level sender to start working. Weird.

That sounds normal to me. Generally take a few miles for the ECU to recheck some of that stuff. Glad you got it sorted.

[Staszek]

Disconnected almost all the last wires and hoses to prepare to pull the M20. Also removed the headers.

[jgilber0]

That sounds normal to me. Generally take a few miles for the ECU to recheck some of that stuff. Glad you got it sorted.

Great - thank you - that is reassuring!

[jgilber0]

Stupid low oil LED on again. So annoying

[Jparkr]

Downgraded the 325i to a 4 banger, Fired it up today.

[d_elson0]

big downgrade....