If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
watched it come off the truck, parked it, vaccumed it, drove it, accidental threw the shift knob at myself when down shifting, feed it gas, parked it the garage, and hugged and thanked if for an amazing first day!
And im currently making a crown royal shift boot for it.
watched it come off the truck, parked it, vaccumed it, drove it, accidental threw the shift knob at myself when down shifting, feed it gas, parked it the garage, and hugged and thanked if for an amazing first day!
And im currently making a crown royal shift boot for it.
about a week ago I cleaned up and repainted my weaves, and today I straightened my bent front valance. Tomorrow I might repaint it because of all the rock chips it has , along with the air ducts, and I also have new fog lights on the way.
Scored a really good shape IS exhaust from the Manifolds back from Lance.
Installed on my eta with all new brackets/mouthing bands/rubber hangers.
FYI the exhaust went on without a hitch. E exhaust manifolds with IS downpipe and rear section! Looks great and very quiet on my little eta.
Um so yesterday my boot ripped off the axle on the passenger side. The boot near the hub and not the assembly. umm how bad is it to drive it like that all torn up etc. Whats the worst that can happen?
Um so yesterday my boot ripped off the axle on the passenger side. The boot near the hub and not the assembly. umm how bad is it to drive it like that all torn up etc. Whats the worst that can happen?
your going to have a fun time cleaning all the damn grease after it gets every where
Comment