Mm hm.
PNW Chit Chat thread
Collapse
X
-
If anyone else has a car that they are about to scrap i need a large section of the trunk pan, mine is rusty and i'd like to just cut it out and weld in a new one.....soooo if someone has a shell they are getting ready to toss i'll pay scrap prices or whatever you deem appropriate.
what section are you needing dude i should be able to cut this out for youStrategic nw e30 commandOriginally posted by bmwm42PNW vulture pm me for partsComment
-
Do not do 15's - way too small.Originally posted by Matt-Bhey does anyone know anyone who gets upset and makes electronics?Comment
-
Comment
-
Basically from where the pan joins the far (rear) wall to just about even with the shock towers length wise and just inside the battery tray and the jack tray on the sides. I'll see if i can get a photo and draw some lines on it to give you a more straight forward idea of the area im talking about
WARNING ULTRA LAME ATTEMPT AT THIS ^ with the white representing the area i need bc mine is all rusty.
Last edited by KEVORM; 01-22-2012, 10:57 PM.Comment
-
Originally posted by SonnyI am a meme for our community.Comment
-

The RM stock 6.5" width is a little too narrow, and $1100 is not that great of a price price. They have potential with widened lips and look better than RSs (to me). Though they're usually less desired and only 2-piece.Comment
-
yes, if it was me id get them, 15x7!!! sounds goodTransaction Feedback: -click here
[e30: '91 318is coupe|brilliantrot||e36: '98 318ti|fern green|California top|M-Tech]
[URL="http://www.r3vlimited.com/board/showthread.php?t=300453"]Comment








Comment