Swap 1/4 Mile Thread

[justin_l_]

Yea, it was junk lol. Smoked bad on decel smoked on accel...now that i think about it i never really didn't smoke! I really wanted to dyno it but never had to money to do it. I wanted the kid that bought it to dyno it but he dissapered off the face of the earth i think.

[JGood]

I'm not too bad at it...;)

You trapped over 100mph.

My best run was 95mph. With slicks and a 3.73 LSD. Dumping the clutch at 3k+ and zero wheelspin. Vanos m50, g260. Dinan chip, CAI, headers, 2.5" single w/ high flow cat/muffler.

My buddy's chipped, AA intake/exhaust 97 M3 traps 97mph.



I'm not saying you are lieing or anything, but something is up with that motor. It is not a typical 170-180whp m50. MPH is a function of power/weight, with little to do with driver ability (unless you really suck). There's no reason, with longer gearing and shitty tires, and a lack of vanos, that you would be trapping 5mph faster then me.

[tonytony]

well in an effort to be lazy i ended up scrolling through more pages than i wanted to haha. I'll just have to wait for next year to run my car. I'll be damn happy if i can break 14s, i've never driving on a drag strip before. here's my setup

NV M50
dinan chip
k&n cone intake with heatshield
uuc pulleys
fan clutch delete
obd2 manifolds
obd2 down pipes
single 2.5in exhaust to a magnaflow cat to a 18in long mangaflow muffler
and royal purple oil for that extra hp increase haha

g260 and 3.73lsd

[416stroker]

Let me know when you are going

I will, I wanna go when the weather cools down or the next grudge race.

I wanna see a m30b35 put down a 13

[Jean]

Let me know when you are going

[416stroker]

Justin is bye far the fastest n/v m50.

I ran a 14.8 the one time I went. But I had didnt have my speed sensor hooked up and had a vacuum leak on the booster. Im go again soon. after I fixed the vaccum leak I can take my brothers lt1 formula its a 14.4 second car.

[justin_l_]

Justin that's great for a 2.5. Do you shift with the gas pedal on the floor?

I lift to shit. I have done flat footed shifting but didn't net any difference, so why ruin the tranny.

so i havne't been keeping up with this thread, it's been 4yrs since i swapped in my NV M50 and still havne't taken it to the drap strip. I'm too lazy to read through all of this, anyway you NV M50 guys, can you PM me your times and specs, pretty please?

The previous page I have two of my times with specs.

[Wh33lhop]

so i havne't been keeping up with this thread, it's been 4yrs since i swapped in my NV M50 and still havne't taken it to the drap strip. I'm too lazy to read through all of this, anyway you NV M50 guys, can you PM me your times and specs, pretty please?

There's a post about 3 back from yours with times. Read through the last few pages of the thread for one or two more.

[MIKe30]

so i havne't been keeping up with this thread, it's been 4yrs since i swapped in my NV M50 and still havne't taken it to the drap strip. I'm too lazy to read through all of this, anyway you NV M50 guys, can you PM me your times and specs, pretty please?

wow, you are lazy..

[tonytony]

so i havne't been keeping up with this thread, it's been 4yrs since i swapped in my NV M50 and still havne't taken it to the drap strip. I'm too lazy to read through all of this, anyway you NV M50 guys, can you PM me your times and specs, pretty please?

[Wh33lhop]

I hope not. I'd like to hope M50NVers can get respectable times without dogging the piss out of the drivetrain.

[Stu]

Justin that's great for a 2.5. Do you shift with the gas pedal on the floor?

[justin_l_]

12s, no problem, unless you suck at drag racing (which is much harder than it looks!)

M50 nv, getrag 250, 2.93lsd junk tires for drifting. Stock engine w/146k, stock ecu, 2.5" exhaust.
R/T .480
60' 2.193
330 6.009
1/8 9.314
MPH 76.37
1/4 14.427 @ 96.64 MPH

New Time
R/T .139
60' 2.193
330 5.939
1/8 9.012 @79.8
1/4 13.920 @ 100.05 MPH
Added my chip and it helped me break 13's finally. Still need to replace my subframe bushings.

I'm not too bad at it...;)

[nando]

I take that as a compliment . I have since sold that to somebody in mass and am currently building slammed hardtop vert with a holset hx35 powered nv m50. Should go like a raped ape. Looking for 350ish to the wheels. Wonder what type of time this is gunna be puttin down...;)

12s, no problem, unless you suck at drag racing (which is much harder than it looks!)

[Wh33lhop]

I take that as a compliment . I have since sold that to somebody in mass and am currently building slammed hardtop vert with a holset hx35 powered nv m50. Should go like a raped ape. Looking for 350ish to the wheels. Wonder what type of time this is gunna be puttin down...;)

Yeah, it was. Get some good tires and keep the stock rear suspension. :p