Looking good!!
Attached Files
-
-
Sexy..... but does it run????https://www.forabodiesonly.com/mopar...re-irs.356333/
This Forum is built on love, and powered by Sexual Tension!
When I die, I want to go peacefully like my Grandfather did, in his sleep -- not screaming, like the passengers in his car.Comment
-
Looks awesome manComment
-
Yes it runs!!! Awyissssss :D I have the video on my Instagram, tried adding it here but didn't work.
Thanks Chris!Comment
-
Awesome!!Comment
-
Ok for those of us who don't have instagram, could post a link to it. I'm not a member and can get in to see it :(Originally posted by Yorl View Posthttps://www.forabodiesonly.com/mopar...re-irs.356333/
This Forum is built on love, and powered by Sexual Tension!
When I die, I want to go peacefully like my Grandfather did, in his sleep -- not screaming, like the passengers in his car.Comment
-
It's a shitty video, but it's something!
Comment
-
Nice!!!https://www.forabodiesonly.com/mopar...re-irs.356333/
This Forum is built on love, and powered by Sexual Tension!
When I die, I want to go peacefully like my Grandfather did, in his sleep -- not screaming, like the passengers in his car.Comment
-
OK, for those asking about header-steering clearance, here's a shot. Good news is I can remove the rack without moving engine and or headers (and that is good)
Comment
-
I didComment
-
This is an interesting Install, great to see it up and running, I am also fitting this engine to a Project here in Ireland.
Ive been watching with interest the installation of the ITB's.
Would you be interested in providing/ machining me a set of the adaptor plates & Throttle linkages for the same installation?
Where have you mounted your throttle cable stay/ holder?
IainComment
-
IIRC the steering delete needs to pass fluid from one side to another. So just capping them off will cause seals to blow with pressure.
Status: HG repair. 488wtq though!Comment
-
It does not matter if those ports recirculate or not, they can be capped off and work just fine. I put my power steering back in, the struggling in parking lots gets old after a while. The other two small hard lines are where all the action happens.Originally posted by shiboujin View PostComment
-
what shop is this done at in Montreal?!!
I'm in Ottawa and never knew such a badass shop existed so close to home...Originally posted by flyboyxComment
-
might not blow the rack seals, but it will make for a tougher steering wheel vs having one of those fancy recirculating blocks.
on a side note, i don't think it really matters since those look like those plastic temp "dust caps/bolts" that come with new racksComment
Comment