Show me your E30 Cup Holders
Collapse
X
-
-
-
This one is an interesting design! Out of the way at least. Looks pretty good.Leave a comment:
-
-
Just make one to replace the map pocket, or use the factory fit cupholder, which is to say the space between the center console and the inner seat bolster.Leave a comment:
-
Ive got the same one except it has the Cigarette lighter outlet with USB charge port! Stephen was the person that made them.Leave a comment:
-
-
A guy used to sell these custom cupholder consoles on here a while ago. There's a good DIY somewhere on how to make em. Up close you can tell the texture is a little off, but I think they look good overall.
Leave a comment:
-
The cup holder/handbrake/armrest section is from the e46 (supports cut/modified front and back). The e30 console was cut and widen to match the e46 and added a section piece to match the curve on the e46 endLeave a comment:
-
Now that is interesting!
did you just replace the entire section around the hand brake? and its a similar width to the e30 one at that join behind the gearstick?
Leave a comment:
-
yer its all about holding the coffee and steering wheel in one hand, and changing gears with the other. Then cleaning the coffee off the steering wheel after reaching your destination.
In saying that i quite like that new design in the first post. but i didn't realise I had to pay to get the STL...
Leave a comment:

Leave a comment: