Danny's 4door Calypso 24v car

[Danny]

Fuel pressure is still solid at 50psi while cranking.

[KenC]

Apology for not reading the whole thing.

180 out of timing?

[MR 325]

I left those loose on my car and it caused issues. To clarify yes I am talking about the two nuts that hold the injector wiring to the fuel rail.

[theryp]

:) me gusta

[LJ851]

does that thing have a cam sensor? If you have spark and fuel, time is all you are missing although your dry compression #s are pretty low. Vanos failure?

[ck_taft325is]

I left those loose on my car and it caused issues. To clarify yes I am talking about the two nuts that hold the injector wiring to the fuel rail.

Super true. Had an "experience" with this right after the S50 was running.

[stinkydriverx]

sounds like timing.
its probably something simple. Just like everyone else is saying, go through with a multi meter.

[trackjunkie21]

How can it be timing if it ran PERFECTLY before? I'm 100% doubting it being out 180*. My bets are on CPS, even though there is spark and fuel.

[Danny]

Apology for not reading the whole thing.

180 out of timing?

Unless I jumped a tooth or something I highly doubtt it. The car was running perfectly two days ago.

I left those loose on my car and it caused issues. To clarify yes I am talking about the two nuts that hold the injector wiring to the fuel rail.

Issues like not starting? Seems strange.

:) me gusta

Thanks man.

does that thing have a cam sensor? If you have spark and fuel, time is all you are missing although your dry compression #s are pretty low. Vanos failure?

It ddoes indeed, you think its bad maybe?

Super true. Had an "experience" with this right after the S50 was running.

Do tell.

sounds like timing.
its probably something simple. Just like everyone else is saying, go through with a multi meter.

Timing thrown out after the car was already running perfect?

How can it be timing if it ran PERFECTLY before? I'm 100% doubting it being out 180*. My bets are on CPS, even though there is spark and fuel.

Cps seems suspect. If I take a MM to it it should ohm to high 500s during cranking?

[Farbin Kaiber]

It's obvious its a signal/ground issue. That's why I said start with pinning out. Coulda found the issue yesterday.


Muchlub<3dannyboi!

[Danny]

How do I start pinning out? I know nothing of etms or wiring.

[Farbin Kaiber]

A powerprobe would be your best friend right now. They also have a sender kit to tone across long runs but I would start with the millimeter on required signal sensors to start, then start tracing the harness out if you don't find anything. Do you have an e36 Bentley manual?

[LJ851]

Danny, you need to learn to FLEX like Farbin. That E30 of yours will get the picture RIGHT AWAY and start walking the line. It wants to be good but i think you need to establish dominance. You are the alpha in this relationship, right?

[Danny]

Right.

Now what signals are required for starting? CPS cam coil packs ECU?

[Danny]

Right.

Now what signals are required for starting? CPS cam coil packs ECU?