After a year of searching, an Alpineweiß story

[iwantspeed]

new ddm hid kit on the way
17mm deep extra long wheel socket
fumoto oil drain valve and extension
mother r3 race rubber remover
and a new pocket knife on the way.

ups hurry up :popcorn::popcorn::popcorn:

[iwantspeed]

what do we have here?

e30 m3 battery tray firewall cover

i have been wanting one of these for a long time and finally got one


installed
still need to lengthen the coil, o2 sensor, ground wires


picture of the oil catch can that I made

[iwantspeed]

thanks

[efficient]

Dang very clean engine bay

[iwantspeed]

Is that the rare Dundler Mifflin overflow for your radiator?

Sure is.

My wife had several friends that worked for Kleen kanteen
And they had a few extra they gave the employees.
And my wife loves the show the office so her friend gave her one.
It got moldy after a while and the wife was gunna throw it out. When I said I could use it

[2mAn]

Is that the rare Dundler Mifflin overflow for your radiator?

[iwantspeed]

I got my valve cover back from powdercoat


My buddy Andrew hooked me up with polished s54 valve cover nuts.

Installed.
With a hidden oil catch can

All new ignition components


Gapping spark plugs


My buddy took this sweet shot on our way to cars and coffee in Aliso Viejo.

[2mAn]

Ok, as long as you are comfortable with it. Like I said, it just looked bad to me, and I thought I better say something rather than stay quiet.

[iwantspeed]

its plenty strong with those plates in there
i dont have extra metal to fab those plates for you.

[2mAn]

the driver side floor plate lands right where the fuel lines go.


i had to remove these 2 studs/posts



all bolted together I rotated one of the bolts so the flat was parallel to the fuel line.



protected the hard lines from chaffing with some fuel tubing split down the middle

Hey Alex,

I was going back through the thread looking at the Harness mounting points we were texting about, and seeing this makes me so nervous. That portion of the body is really thin and in a worst case scenario that plate could puncture through the fuel lines making a bad situation a LOT worse. Maybe Im just being paranoid, but this scares me and I would rather speak up about it now, rather than later...

In other news, I will probably use your link to purchase the stuff to mount the harness, do you have enough spare metal to make me a set of your plates?

Hope to see you on the track soon!

-Simon

[iwantspeed]

for my next project im working on oil catch can.

in preperataion for that i had a friend weld on a AN fitting to the valve cover.
check them out
instagram
grand_master_fab










with the fitting im going to use mocked up


once the fitting was welded on i masked the valve cover


media blasted it



now its ready for powdercoat

[minsanity]

This thread leaves me speechless always!!!
Love your work, Alex!!!! Top-notch!!!:)

[iwantspeed]

[iwantspeed]

[iwantspeed]