A look at things to come

[Matt-B]

change things up to what? I find most other wheels I like are to expensive, impossible to find, and most are boring.

I want 16" hartge or something of that nature. And I feel 2,000$ is a bit much.

[Matt-B]

enjoy. decided, to screw fixing dimples on valve cover. to cold outside for drying and decided not to wait for it to dry again

[Edev]

Ah so you're the one who sent me a picture text of a motor. I wasn't sure who it was. You're getting closer and closer though. Do you have a rough estimate as to when it'll be running and driving?

[White325is]

Im gonna help you now by telling you that you need spacers under them there 6 bolts holding on your trigger wheel. Or when you go to start the motor, it wont turn over. Then you will be making a "why wont my 24v swap start?" thead.

[Matt-B]

I used washers, but should i cut the middle out of the AC pulley or something?


Eric: Month? i still need to do my engine bay....not so much shave, as a clean and paint.

[Edev]

I used washers, but should i cut the middle out of the AC pulley or something?


Eric: Month? i still need to do my engine bay....not so much shave, as a clean and paint.

Now that sounds good. I can dig it.

[White325is]

Doesnt look like you added anything. Thats the reason why I said that.
I figured you would have tossed in some new washers and wire wheeld them old bolts and paint the trigger wheel.

[Jand3rson]

Wire wheeling bolts... that I'm not looking forward to. But ain't no way I'm putting a bunch of dirty, grimy old bolts back on my shit.

[Matt-B]

Yea i got some in there about same diameter as bolts. Ill double check width also...

got your text thanks :) just need a starter and I essentially have everything


I have to wire wheel quite a few things hardware wise to :(

[White325is]

Wish I would of known. I have a started for single mass M20 flywheel sitting right here.

[Matt-B]

My flywheel is a lightened E flywheel.

I guess you have to match the teeth up? As some are different

[nando]

Wire wheeling bolts... that I'm not looking forward to. But ain't no way I'm putting a bunch of dirty, grimy old bolts back on my shit.

just buy new ones. I wasted an entire *day* cleaning old nuts and bolts, I could have bought all new ones for like $50 and gone to the movies or something instead..

[ShowStopper]

i bought most of my bolts new..still need some for the trigger wheel.

[Jand3rson]

just buy new ones. I wasted an entire *day* cleaning old nuts and bolts, I could have bought all new ones for like $50 and gone to the movies or something instead..

Meh, that sounds like more of a pain in the ass than cleaning them. I'd spend an entire day trying to order the right quantity and size of every bolt on the engine, I'd rather just clean them. Not to mention, a total waste of good hardware and money.

[samiam3356]

Meh, that sounds like more of a pain in the ass than cleaning them. I'd spend an entire day trying to order the right quantity and size of every bolt on the engine, I'd rather just clean them. Not to mention, a total waste of good hardware and money.

Just take the bolts with you to the hardware store and they will match them up for you. Any decent hardware store anyway.

You can also let them sit in purple power over night and that shit will about eat anything off them. You won't even have to wire wheel them. or at least i didnt.