Kamotors E30-Turbo to ITB M20

[RagtopE30]

LOL Yeah go ahead and get the stage 5!

[jalopi]

I've never been a big fan of unsprung clutches.

So what does Spec usually charge for a disc? Tell them $100, then you'll be happy and not flame them. If they can't cope with taking a hit on a manufacturing defect I'd say they either have poor business practices or they have an inferior product. Call them out on it, in a polite way, and I'm sure they'll budge more.

[IronFreak]

I've never been a big fan of unsprung clutches.

ppssshhhhh.....Unspung whozeewhatit?

You need one of these!

[Jb325is]

^ Have you driven your car yet with that? They are a huge bitch to drive on the street or anything under WOT and they wear really quickly since you have to slip it so much at low speeds

[kamotors]

ok so got the stage 5 disc ordered came to $244, couldn't get it any cheaper

[RagtopE30]

Good! Make progress and move on.

[LJ851]

ok so got the stage 5 disc ordered came to $244, couldn't get it any cheaper

That's the spirit !

[jalopi]

Goddamnit... so no shadow war against spec? If it's any consolation, I'll never buy anything from them now.. hope you're reading this, spec rep

[kamotors]

They still treated me better than a lot of other venders, so they kept my business. lets just hope I have no more issues, I want to crank the boost up:)

[jalopi]

[IronFreak]

^ Have you driven your car yet with that? They are a huge bitch to drive on the street or anything under WOT and they wear really quickly since you have to slip it so much at low speeds

Yes, a good friend has a 7.25" tilton setup behind his m30 and it streets just fine, noise would be my only complaint in a street car and well.... My car isn't for street use so I'm not to worried. Keep it up Kam, I want to see that thing ripping it hard.

[kamotors]

Well...:( :( :(
I'm NEVER ordering a clutch from spec again. SECOND CLUTCH disk and its bent again, never been installed, I checked this one as soon as it was opened. Upon Closer inspection one of the rivets isn't even in all the way. They blamed me the first time saying I bent the disk on install but here's proof that that's not the case. Has been tested in 2 transmission. Its just junk. I have a total of $700 in garbage now, original clutch was $500 and now another $200 in replacement disk. have videos of proof.
pic of rivet.
far right rivet not in all the way.


videos soon

[kamotors]

videos of it in 2 different trans rubs on same puck everytime
g260 #1


g260#2

[ForcedFirebird]

Hopefully they will take care of you with the proof of bad parts. Have never dealt with Spec, good to know.

[Good & Tight]

Man that really sucks, hope they get it sorted out for you.