325IX restore and build continued(turbo, e34ix diff, DCT)

[nomansland92]

Think I'm done for the day but made some progress answered some questions.






My jig to hold the axle, the paint is so I know exactly where it sits.


With the 525ix diff loosely bolted to the axle. As you can see in the pics the upper mount hits the block and is stopping it from being rotated into place. I think if I cut the mount off and move it then it will clear everything. It's definitely going to be one hell of a frankenpan.



It even clears the rack, who would of guessed.

[Nisse Järnet]

Cool man!!

[nomansland92]

Well I cut tab off, fits like glove. I guess I'll start cutting the pan up next.

[wodcutr]

I see what you are doing now with all those parts. You are doing things that no one else has done and your work looks awesome... Very nice!

[nomansland92]

I see what you are doing now with all those parts. You are doing things that no one else has done and your work looks awesome... Very nice!

Yep parts are in good use :p I don't think anyone has ever put a 525ix diff under a m20.

[iXguido]

how much power are you planning to make???

[nomansland92]

how much power are you planning to make???

I'm shooting for at least 500awhp

[Nisse Järnet]

Yep parts are in good use :p I don't think anyone has ever put a 525ix diff under a m20.

I know of one guy actually :)

[nomansland92]

I know of one guy actually :)

Ha really, well I guess I know is possible than. I know you did it with the m50 but do you have any pics of the pan with the m20? I've been debating on how I want to cut it

[nomansland92]

Been pretty busy, been working on my new/old quad that i got talked into buying by my friends because I guess two dirt bikes isn't good enough haha. Anyway I worked on the pan a little bit. Just rough cuts will need to be trimmed a lot more.

This is the 325ix pan






Here is the 525ix center piece




Also it seams that I'll need to cut the front driveshaft down by 1.5" because the passenger half shaft will hit the cross member otherwise. This of course causes interfaces with the oil pickup tube.

[Kershaw]

Nice progress.

[Nisse Järnet]

Ha really, well I guess I know is possible than. I know you did it with the m50 but do you have any pics of the pan with the m20? I've been debating on how I want to cut it

No I don't :( Nut he used the E34 ZF and tc so the M20 was tilted like the M50.

It looks good so far! Looking forward to see more!

[2mAn]

damn this looks crazy, I will have to go through the full thread tomorrow when I get bored at work

[nando]

did I sell you these parts? I can't remember who bought them. lol

[nomansland92]

did I sell you these parts? I can't remember who bought them. lol

Yep dont they look familiar haha