SoCal General Chat

[XwalkerX]

isnt autopower in san diego? im sure they know what they are doing...

[ethrtyiS]

hey guys don't wanna start a thread for it just yet, but anyone know of any good socal shop that I can trust to make me a roll cage?

Call JMP Autowerks in Reseda. They no longer make them in house but Alan is still making them at his home. Jerick at JMP can direct you to him. 818-457-4967.

[IRON-E]

hey guys don't wanna start a thread for it just yet, but anyone know of any good socal shop that i can trust to make me a roll cage?

call jmp autowerks in reseda. They no longer make them in house but alan is still making them at his home. Jerick at jmp can direct you to him. 818-457-4967.

+1

[E30SPDFRK]

Anyone know any good shops around that rebuild BMW driveshafts? Preferably in OC but I'll bring it to LA if I have to.

The only place I've found so far that does BMW ones is Drivelines Inc. in Mission Viejo, but they want $450 for the 1 new u-joint and balancing and fuck that.

[LowR3V'in]

http://www.driveshaftpro.com/gardengrove

They did a good job putting in a greasable u-joint.

[LowR3V'in]

Also, does anyone have an undamaged m30 piston thy would like to sell me?

[E30SPDFRK]

I actually just called them at lunch, they seemed like they knew what they were talking about, quoted me $375. Is that about what you guys pay out here? I used to have a shop in RI that would do it for $200. I mean, u-joints are $20 each at most, and it should only take 2 hours of labor if you're going slow.

Has anyone found a source for replacement u-joints?

[efficient]

I think bma sells them. ^

[MR 325]

I actually just called them at lunch, they seemed like they knew what they were talking about, quoted me $375. Is that about what you guys pay out here? I used to have a shop in RI that would do it for $200. I mean, u-joints are $20 each at most, and it should only take 2 hours of labor if you're going slow.

Has anyone found a source for replacement u-joints?

That's about normal price. The place I've used in Monrovia was $350.

I know Ireland Engineering has a place they use often. You could call Andrew and ask.

[efficient]

Front wheel hubs went up in price. :/

[2mAn]

two weeks since i ordered it and I still dont have my hub...

#italvolantiproblems

[QUKBMER]

What hub ? Wheel hub?

[reelizmpro]

Who's going to the Irvine picnic?

[2mAn]

What hub ? Wheel hub?

Ive owned an Italvolanti Formel steering wheel for over 2 years now. I finally broke down and ordered the hub from Pelican

[CENTURION]

anybody know of a muffler shop with 24v swap experience?
IE county preferred. I need a dual mid section made.please and thanks