NOR-CAL General Chat.

[ohthejosh]

Def needs beefier tires spency

[wilholl]

anyone have a spare plate that goes between a m50 and its trans?

I have one, either manual or autotrans style.
The autotrans style has extra holes for access to the convertor bolts.
FYI: only about $10 new

[Pantless Spency]

Def needs beefier tires spency

It does. Or more low.

Here's some better pics for you guys, car is filthy.

[Cabriolet]

This is the only way i could get as much fender gap as Pantsless.

Wilwoods installed
New Control arms installed
M3 CABs installed
Hammered my left hand, missed the pickle fork with a 3lb sledge.
Smashed my left pointer figure in the press. lollipops are a bitch

[Steven]

Hammered my left hand, missed the pickle fork with a 3lb sledge.
Smashed my left pointer figure in the press. lollipops are a bitch

I LOL'd

[Thizzelle]

i want to change my lollipops but i hear they are a bitch to change :(

[Pantless Spency]

i want to change my lollipops but i hear they are a bitch to change :(

Just depends.

You should remove the tie rods to make life easier... Not sure about removing but when we were installing my e30 m3 offset lollipops on some uro control arms.
On the pass side we actually had to grind down the control arm to accommodate the lollipop bushing. It was horrendous,the drivers side was really hard but it would actually stay on.
Passenger side literally could be squeezed on 3/4 of the way with soap and w2-40 and then once you let off pressure it would just pop off slowly but surely.


Moral of the story, never get uro parts there garbage.

[Pantless Spency]

[Steven]

What: Meet today 8/7

Where: The Plant (Best Buy parking lot)
1 Curtner Ave, San Jose, CA 95125

When: 7 pm

Be there or be square.

[Toodaloo]

What're your guys' opinions on this? I really don't see what can go wrong. It's supposedly the same height as the stock shifter, (but obviously a much shorter throw.)
It uses the oem pivot cup so I really can't see what would go wrong with it. And for $25, it's a steal.

[Steven]

https://www.facebook.com/events/898830220207623/

[Rsully70sev]

Lol pantless, I was stoked when I saw your snapchat...but what are thooooooooose!

Needs more beef, those tires are vegan as fuck.

[Cabriolet]

What're your guys' opinions on this? I really don't see what can go wrong. It's supposedly the same height as the stock shifter, (but obviously a much shorter throw.)
It uses the oem pivot cup so I really can't see what would go wrong with it. And for $25, it's a steal.

just get a z3 one. going overly short like that actually makes it worse to shift. unless you raise the cut up.

[kronus]

We run one of those $25 shifters in the lemon. The hole for the selector rod is drilled too small from the factory - you'll have to open it up with a drill to fit an e30 rod.

Other than that, no complaints. Short shifts, no rubber to wear out.

[Pantless Spency]

Lol pantless, I was stoked when I saw your snapchat...but what are thooooooooose!



Needs more beef, those tires are vegan as fuck.

Haha thanks dude. Yeah they're a little small, next time around I'll get beefier