It's getting cold up here. I'm getting annoyed.
-
Originally posted by Matt-B -
-
I'm outside washing a car right now. Brrrr.
Sent from my LG-P999 using Tapatalk
clutchCTRL!Move with a purpose.- 1991 325iX 4dr/5spd- 1976 2002 SlickTop/2.7i M20/G260- 2000 323i AT2016 Mazda CX3 Sport AWDComment
-
-Brad, AlphaTeam Motorwerks, LLC
91' 318iS - S54/6MT Swapped
08' E90 M3 6MT - Daily
04' Chevy Duramax CCLB - Work Truck/Hauler
Originally posted by IronJoe
Alpha Team: running through e30s, gringo icebergs, and 19 yr olds.
Originally posted by 2mAn
Brads a standup guy even though he likes buttsexComment
-
Please tell me your using BMW blue coolant? Haha.
Sent from my LG-P999 using TapatalkclutchCTRL!Move with a purpose.- 1991 325iX 4dr/5spd- 1976 2002 SlickTop/2.7i M20/G260- 2000 323i AT2016 Mazda CX3 Sport AWDComment
-
Deleted my pinstripe today and got my 13 button OBC installed and working. Avg mpg works and so does the range...sorta. I installed it with the low fuel light on (no working gauge) and went to the Chevron and put $20 in and it said I had 31 miles...fail.
Comment
-
How easy was the swap? I'm getting ready to go from 6 button to 13. Any tips or write ups?
Sent from my LG-P999 using TapatalkclutchCTRL!Move with a purpose.- 1991 325iX 4dr/5spd- 1976 2002 SlickTop/2.7i M20/G260- 2000 323i AT2016 Mazda CX3 Sport AWDComment
-
Actually, really wasn't that bad. I didn't connect the green or blue plug as I didn't need them (green is fuel cutoff and blue is for turn signal stalk.) The black one I hooked up to the door chime and the white one i connected to the ambient temp sensor (which was another white/blue wire as it is on the 13 button harness.)
Make sure you connect the OBC before mounting it in the HVAC panel. I tested mine before hand and it had a bulb out. Luckily, I had another one so I pulled it out and swapped it. I would've been pissed if i didn't because it's kind of a bitch to get in/out of there.
One thing I did which helped is I removed the top/bottom screws on the right side of the HVAC panel. Obviously, they're going to be a tight fit when replacing, so I put the screw on a small #1 philips and put some electrical tape on it so it didn't fall off, but enough to allow me to pop the screwdriver off when I got the screw all tightened.
Sorry for the novel! Hope this helps you, I didn't have shit and had to fuck around and learn for myself! Lol.
Comment
-
Comment
-
Just want to whore my car out...
Comment
-
-
dayummmmComment
-
^^^ Looks fantastic
Comment
Comment