E30 M42 Touring -92 // bagged + turbo build thread ** #119 Dyno 593hp/611nm @hubs

[potatomash]

Is that on e85? I'm only 30hp more with a stock m20 but on 98 fuel

[krisu]

Is that on e85? I'm only 30hp more with a stock m20 but on 98 fuel

Yes, it has a lot to do. i use e85!

[ZodGilla]

Is that on e85? I'm only 30hp more with a stock m20 but on 98 fuel

Why are you running 98 if your M20 is stock?

[2mAn]

Why are you running 98 if your M20 is stock?

its a turbo M20

[potatomash]

Yes, it has a lot to do. i use e85!

Hmm think I need to go e85 then haha.

Stock M20 as in stock internals and a big single ;)

[ohthejosh]

Absolutely well done.

[krisu]

Absolutely well done.

thanks ;)

[krisu]

It was time to put the touring to winter storage, its so cold in here already.. there is some last burnout videos on my instagram page and youtube, so go check em out! youtube vid

now it is time to open the engine and replace headgasket and put arps in there. I already have a m47 crankshaft, so i might be stroking the engine to 2liter. custom pistons and 135 or 140mm rods should do the job, we'll see!

also interior is going to get upgraded this winter!

[econti]

Stroker sounds very exciting

[Mr. Wolfe]

Beautiful car. Just figured I would let you know that I am selling 2 mint condition 4" radinox lips for Schmidt (30 bolt) wheels. Not sure if you have any use, but there are not a ton of Schmidt owners on here so I figured "why not?".

https://www.r3vlimited.com/board/showthread.php?t=415846

Mr. Wolfe

[krisu]

Stroker sounds very exciting

it sure does ;D

Beautiful car. Just figured I would let you know that I am selling 2 mint condition 4" radinox lips for Schmidt (30 bolt) wheels. Not sure if you have any use, but there are not a ton of Schmidt owners on here so I figured "why not?".

https://www.r3vlimited.com/board/showthread.php?t=415846

Mr. Wolfe

thank you! oh, god damnit i actually could use them for my front wheels.. any idea how much shipping costs would be to Finland? :roll:

[Mr. Wolfe]

it sure does ;D



thank you! oh, god damnit i actually could use them for my front wheels.. any idea how much shipping costs would be to Finland? :roll:

Personally, I would want $250 in my pocket as that is less than half price and they are mint. If I can get them to you for $350 or less, would you be interested? Sorry to clutter your thread! I should have PM'd you this.

Mr. Wolfe

[krisu]

Personally, I would want $250 in my pocket as that is less than half price and they are mint. If I can get them to you for $350 or less, would you be interested? Sorry to clutter your thread! I should have PM'd you this.

Mr. Wolfe

Np, pm'd.

[krisu]

Hi all, been lazy and have not updated this thread for a while :)

During last winter, i changed new original headgasket, arps, idlecontrolvalve, turbo oil and water lines, leather interior etc.. I have already taken the car out of the garage and been driving it for a while. it works good!

I am going to drive with this engine this summer, planning next engine probably for next season. I have small doubts on this engine tho, because one cylinder had little bit damage cause the blown gasket, nothing too serious but we will see if it blows i'll change just a new original motor there to drive the rest of the summer.

For this summer planning to add bigger electric fan, and probably electric water pump and a new wheel

some imgs

[econti]

Should be fine, they're tough little things