PNW Chit Chat thread

[Mlarsen]

Matt, you better do whatever you can in your power to go to the Ring

It'll be closed. :(

[1craze30]

PNW Chit Chat thread



That's what I'm talkin bout! Done with the bumper. I still have to do the rear, but now that I have a handle as to the scope of the project, it'll go much faster.

I'm also finishing my lower valance, and for the mean time while I hunt down some fogs, is there an option besides chicken wire to cover those holes?

[2mAn]

It'll be closed. :(

that sucks

[AbeSonic]

Sup everyone

[e30austin]

Anyone know of any smilies for sale? I need.....one.

I have a few boxes of headlights. What side do you need and what brand?

[the imitator]

Just wanted to give a heads up, in order to further fund the n54 swap I am selling the m30 swap, with all of those parts I bought but haven't used, just installed.

M30b35, 178,xxx miles, new headgasket
done 1000 miles approximately. Cross hatches looked amazing!
Freshly installed, rear main seal, crank seal, oil pain gasket, cam seal, valve cover seal, pilot bearing.
Injectors cleaned and flow tested with paper work
ARP headstuds
Gman poly mounts
Garagistic motor mounts drilled for position 3.5

G265 OD Trans
Freshly installed input and output shaft seals, and shifter seal
Single Mass flywheel resurfaced not used
M5 clutch disc brand new
Clutch slave cylinder brand new
Throw out bearing brand new
G260 output flange swap
E30 M3 transmission mount
E30 m3 Akg poly offset transmission mounts

Fluids are royal purple freshly poured both transmission and motor, so i suggest the purchaser not drain before transport if possible.

Fully sorted harness for late model included,179 ecu with the great Mark D chip installed

Full exhaust available, 2.5 inch, with fresh cat, and Flo pro muffler.

Let me know if any of you guys are interested.

Damn after looking at the past few pages, makes me wish I was up in PNW still, and can't wait to be back up there.

[e30austin]

Too bad I just bought another s50. Would have totally considered this.

[OldDrunkenSailor]

I have a few boxes of headlights. What side do you need and what brand?

I believe driver's side. The one that I have left is OEM, not sure what that makes it for brand.

[e30austin]

Hella or Bosch. There is a difference.

[AbeSonic]

You might say there's a hella difference.

[Pdxseth]

You might say there's a hella difference.

Only if eating at jack in the box.

[Mlarsen]

that sucks

I know we'll be back over there. We want to go in summer, do the ring and my GF has family in Stockholm. The fact that I'm not going to do the ring alone is worth going back over there.

[2mAn]

Plus the exchange rate is finally evening out. I'm hoping to go at the end of May

[e30austin]

Only if eating at jack in the box.

Those commercials tho...wtf

[moreoff]

anybody want/need an s50 block? $200

i also have a turner setup for an s50 including chipped ecu/injectors/euro maf

gives another 19hp and 16ft/lbs of torque to a 95 m3.

$300