If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Need advice on wiring an early starter to a late model harness.. Mainly what to do with the Unloader Relay Wire (Black/Green Stripe).
Mine's not connected any everything works just fine. 89' harness and 84' starter. I only have two wires (plus the thick red) connected and the unloader i left off.
edit: its a racecar so i dont have windows/sunroof/ whatever else to worry about.
Also when i went to start it for the first time i had the black/yellow on the wrong spade, wouldn't crank. IIRC it goes on the bottom one not the top one (could be backwards, moral of the story is if it doesnt crank switch the black and yellow to the other spade).
KEV with it setup the way you have it are you able to roll windows down? That's my main concern.
Did you have to add a spade connector to the black and yellow wire? PM me. That may be easier! The car in question is a track car as well.
IIRC, the starter i'm dealing with (early) only has two threaded posts, and one spade on TOP in the middle between the two threaded posts. I'll double check for a second spade below the posts when I'm home. Thanks.
Glad you figured it out, Paolo. Sorry for not responding, just super busy today and forgot to. Did you just hook up the two small wires to the one small post?
Comment