If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
M20 3.0 stroker build - looking for advice from the M20 gurus
Hi all,
I'm planning an N/A M20 stroker and would really value advice from the M20 gurus here. I have quite a bit of engine building experience, but I'm new to the M20 and its quirks, so...
BMW E30/325i/E32/E34 1987-1993 MSPNP Gen2 Plug and Play ECU
have a old ECU sitting around collecting dust that I purchased new for a turbo m20 525 build which I've decided to leave NA. willing to get rid of it including a wideband and a tps with tps bracket from...
Where are the r3v legends as well as the dumbfucks of r3v IE 5hoes haha I know we are older and such but I do miss the r3v of what seems like a very distant memory now.
I just installed a Schrick 284/272 and set it to what I think is supposed to be the TDC center position based on the German catalog. The #1 intake valve is open 2.2 mm and the #1 exhaust is open 1.7...
Can Brake Balance Be Maintained E32 Master Cylinder?
I have a brand new ATE stock size MC and entirely refreshed brake system. All calipers were stripped, cleaned, and rebuilt and the rears were upgraded to solid bushings. New stainless hoses all around....
Back in 1996 my Dad purchased this beauty for his daily driver. Fast forward to the mid 2000s and my Mom started using it as her daily, skip ahead to mid-2010s and they retired it as the project/weekend...
š E30 Sport Seat Fire Extinguisher Bracket ā Group Buy! š
Proud to announce a group buy for a plug-and-play fire extinguisher bracket designed specifically for E30 Sport Seats. I engineered this...
M20 distributor limitations and timing advance effect on the spark
does anyone know what is a design gap between distributor rotor and cap posts for each cyl when rotor is just above it? I roughly measured both and it's about 2mm. Basically what I see with my cam at...
What it says on the tin. I was planning to eventually get it refurbished anyway then read it was a common hint of the board batteries on their way out, so I sent it off to Bavrest as that was a good excuse....
Iām building a 2.7 stroker and am looking to get a 885 head worked on, are there any machine shops that anyone could recommend in Colorado Springs or Denver area?
Thanks!