1990 325is restomod project aka "Klaus"
Collapse
X
-
-
-
You are correct on both counts. There are a few people that merged to early with adverse effects.Comment
-
Comment
-
Originally posted by KIRIEIW;4928791Question, did you buy a new firewall grommet or did you rob the one off your original M20 harness? Were you able to stretch it over the ECU harness plug? I'll need to do mine this weekend.
Here's my pic of the wiring which is going back in.....Comment
-
Check my thread out too if you want, but I was able to fit all the wiring, and 2 additional sets of relay wiring I added along with wideband O2 wiring in my grommet. Just soap it up!
Here's my pic of the wiring which is going back in.....Comment
-
Comment
-
Yep, we will do a baseline of the car as is once it's running. Then tune than a dyno after the tune as well.
I will post both. He was in agreement that the merge should be behind the cats, he has seen a few S54s with merge right after the headers and the power loss was pretty great.Comment
-
Yep, we will do a baseline of the car as is once it's running. Then tune than a dyno after the tune as well.
I will post both. He was in agreement that the merge should be behind the cats, he has seen a few S54s with merge right after the headers and the power loss was pretty great.Comment
-
I BUY/SELL REFURBISHED CM5907s & CM5908s
HOWTOs:
DB vert plastic bumpers
OEM Keys
MTech1 docs
88 ix Lach/Card
91 ic Calypso 3.1
86 Cosmo 2.7
OEM+ or bust!
reelizmpro: I will always be an e30 guy.. I still do all of my own labor
TrentW: There's just something so right about a well-built M20 in an E30
e30m3s54turbo: I save my money for tuner parts.Comment
-
Looks closer then it is. It's about the same distance as the stock ones. I will take some measurements.Comment
-
They are slightly lower than the oil pan on one side by a few MM. I will measure it, but I dont think it will be a problem because its higher then the original E30 Oil Pan was.
If I scrape that then I am pretty close to scrapping the oil pan as well which would be bad.
I am lowered but not slammed. See if I can get some pics with the car on the ground underneath.Comment
-
Subed!
Very sweet build. Are you going to use the stock E30 fan with the E46 PWM controller for the A/C?Comment
-
Comment
Comment