Originally posted by kinvodA
View Post
Announcement
Collapse
No announcement yet.
PNW Chit Chat thread
Collapse
X
-
Originally posted by KEVORM View PostIf anyone else has a car that they are about to scrap i need a large section of the trunk pan, mine is rusty and i'd like to just cut it out and weld in a new one.....soooo if someone has a shell they are getting ready to toss i'll pay scrap prices or whatever you deem appropriate.
Comment
-
Originally posted by LuckyHenriksen View PostCould you use part of an E28 trunk floor?
Comment
-
Hell yeah! Propane torch did the trick and the tie rods came off. Passenger side relatively easy after 45 seconds of heat.
Driver side took a few cycles of heat. The monkey wrench would not stay on, and YES I knackered the hell out of it, but vice grips with a cheater did the trick.
Also I dropped the sway bar to get to the passenger side inner ball joint nut, did the trick and that is off too.
Now just need to go back out another day and get the control arm and strut assembly off.
Feel so accomplished, lol
Comment
-
Glad you were able to figure it out toes.
Strut assembly should come out fairly easy once you get all the ball joints, etc off-Brad, AlphaTeam Motorwerks, LLC
91' 318iS - S54/6MT Swapped
08' E90 M3 6MT - Daily
04' Chevy Duramax CCLB - Work Truck/Hauler
Originally posted by IronJoe
Alpha Team: running through e30s, gringo icebergs, and 19 yr olds.
Originally posted by 2mAn
Brads a standup guy even though he likes buttsex
Comment
Comment