e30 325ix-86: with a Finnish touch
Collapse
X
-
-
i think he meant since youre so open to hacking and customising , why not ditch the booster and run a pedal box setup. also you can build a proper setup with stock booster. some even shift the stock booster over an inch or so which would make it 10x easier to make a plenum. also smaller booster and corresponding caliper and m/c changes along with the offset position and would help again
Comment
-
new ignition coils
heater pipes are going to need some modifications too
Comment
-
Took some practices to the students at school ;)
Now when I have centering hub for the flywheel, it's time to
put it on a diet.
Comment
-
Love everything! Craftsmanship and creativity like this is very respectable. Thank you for sharing with us :)Comment
-
just ordered one of these ;) I want to hear the straight pipe, but not all the time ;) plan is to take 2x2,5" pipe from front to the back, 2-to-1 joint after collectors and then cut out shares it back to 2x2,5" which will lead to the back of the car, one silenced, one straight.
Prepping flywheel to be machined.
Comment
-
I must say,,, VERY WELL DONE,,, so farSveinbjörn Hrafnsson
E30 CABRIO V12 M70B50 ///
ALPINA B10 BITURBO 346 @ 507
E34 550 V12 JML
Finnish wisdom : If you want to Win,, hire a Finn
http://alpina.123.is/pictures/Comment
-
-
electrical cutout system arrived from the US :)
And facelift CPS combo came from the UKComment
-
Taking final measurements from the crankshafts
So the m20 crank bolt bottoms in m57 crank. Problem is that m57 has longer threads in the crankshaft.
Bought m57 flywheel bolts for automatic transmission. Same size, only longer threads.
And it fits!Comment
-
Don't forget the gall plate adds a another couple mm so you have more margin
https://www.ecstuning.com/ES20337/Last edited by digger; 11-22-2015, 02:43 PM.89 E30 325is Lachs Silber - currently M20B31, M20B33 in the works, stroked to the hilt...
new build thread http://www.r3vlimited.com/board/showthread.php?t=317505
Comment
-
Don't forget the gall plate adds a another couple mm so you have more margin
https://www.ecstuning.com/ES20337/Comment
-
Sold my volvo and bought toyota hj60 from Lapland! :)
back in home
HJ needs some repair before it can be thrustworthy daily :)
Starter motor gave up so I had to took it apart and fix it.
new bearings and bendix unit
Took the front output shaft out because it started making a noise also
Little wear so I'm going to use it only in L4.
Greased it well and installed back in the car.
Comment
Comment